Tabla de contenido
Power Failure
As a precaution, the switch should be unplugged in case
of power failure. When power is resumed, plug the switch
back in.
Management Options
This system may be managed out-of-band through the
console port on the front/back panel or in-band using
Telnet. The user may also choose the web-based
management, accessible through a web browser. Each
Switch must be assigned its own IP Address, which is
used for communication with an SNMP network manager
or other TCP/IP application (for example BOOTP, TFTP).
The Switch's default IP address is 10.90.90.90. The user
can change the default Switch IP address to meet the
specification of your networking address scheme.
Web-based Management Interface
(depending on the purchased model)
After a successful physical installation, you can configure
the switch, monitor the LED panel, and display statistics
graphically using a web browser, such as Netscape
Navigator (version 6.2 and higher) or Microsoft
Explorer (version 5.0 and higher).
You need the following equipment to begin the web
configuration of your device:
• A PC with a RJ-45 Ethernet connection
• A standard Ethernet cable
Step 1
Connect the Ethernet cable to any of the ports in front
panel of the switch and to the Ethernet port on the PC.
Figure 7. Connected Ethernet cable
Step 2
In order to login and configure the switch via an Ethernet
connection, the PC must have an IP address in the same
range as the switch. For example, if the switch has an
IP address of 10.90.90.90, the PC should have an IP
address of 10.x.y.z (where x/y is a number between 0 ~
254 and z is a number between 1 ~254), and a subnet
mask of 255.0.0.0.
Open your web browser and enter http://10.90.90.90
(the factory-default IP address) in the address box. Then
press <Enter>.
Figure 8. Enter the IP address 10.90.90.90
The web configuration can also be accessed through the
DNA. You can click the IP hyper link in the device list in
the DNA to open the web GUI of devices.
Step 3
When the following logon dialog box appears, leave both
User Name and the Password in blank then click OK.
This will open the Web-based user interface.
Internet
®
Figure 9. Enter Network Password window
DNA (D-Link Network Assistant)
The DNA (D-Link Network Assistant) included on the
installation CD is a program for discovering Smart
Switches with the same L2 network segment connected
to your PC. This tool can support windows 2000, XP,
Vista, and Windows 7. There are two options for the
installation of DNA (D-Link Network Assistant), one is
through the autorun program on the installation CD and
the other is manual installation.
Option 1: Follow these steps to install the DNA
(D-Link Network Assistant) via the autorun
program on the installation CD.
1. Insert the CD into your CD-Rom Drive.
2. The autorun program will pop up automatically
3. Simply click on the "Install DNA (D-Link Network
Assistant)" button and an installation wizard will guide
you through the process.
4. After successfully installing the DNA, you can find it
under Start > Programs > D-Link > DNA.
5. Just connect the Smart Switch to the same L2 network
segment of your PC and use the DNA (D-Link
Network Assistant) to discover the Smart Switches.
in the web browser
NOTE: The switch's factory default IP
address is 10.90.90.90 with a subnet
mask of 255.0.0.0 and a default
gateway of 0.0.0.0
3
Tabla de contenido
