Connecting The Boundary Wire To The Charging Station; Switching On And Off; Setting The Pin; Forgotten Pin - Grizzly MR 400 Traducción Del Manual De Instrucciones Original

Ponds/pools
Ponds and pools should be bordered by
the boundary wire (6) where possible
or designed so that the automatic lawn
mower cannot enter the water. This may
seriously damage the device's electronics.
Paths/roads
The automatic lawn mower can easily
cross paths and roads at ground level.
If height differences exist between the
lawn area and path/road, border off the
path/road with a safety margin of approx.
40 cm.
Narrow passages
Narrow passages on the bordered lawn
area should be at least 1.2 m wide and no
more than 8 m long (see figure
Connecting the boundary
wire to the charging
station
1. Strip approx. 10-15 mm of both ends
of the boundary wire (6) using cable
strippers.
2. Connect the rear end of the bound-
ary wire (6) to the contact jack (28)
marked with "S1".
3. Pass the other end of the boundary
wire (6) through the groove (29) under
the charging station (12).
4. Connect this end of the wire to the
contact jack (27) marked with "+".
5. Check the LED (25) on the charging
station.
If the LED (25) lights up green, the
boundary wire (6) is connected to the
charging station (12) correctly.
Switching the automatic lawn mower on
1. Press the on/off switch (5) on the un-
derside of the automatic lawn mower
(position "1").
2. Press the power key (16) on the con-
trol panel.
Switching the automatic lawn mower off
3. Press the on/off switch (5) on the un-
m ). derside of the automatic lawn mower
(position "0").
1. Unlock the control panel (2) with
the PIN (factory setting: press keys
marked "1-2-3-4" in numerical order).
2. Simultaneously press the OK key (19)
and the lock key (20).
The lock LED (30) flashes red/green.
3. Enter a new 4-digit PIN using the keys
marked "1-2-3-4".
4. Confirm the new PIN with the OK key
(19).
The automatic lawn mower beeps to
confirm.

Forgotten PIN

1. Open the battery compartment (
on the underside of the device.
Allow a metre of additional space
for corrections when installing the
boundary wire (6).
Do not place the "protruding"
remains of the boundary wire
together. This can lead to faults
and failures in the automatic lawn
mower's operation.

Switching on and off

Setting the PIN

GB
31)
91