Moulinex hapto Manual De Instrucciones página 15

• This product has been designed for domestic use only. Any commercial
use, inappropriate use or failure to comply with the instructions, the
manufacturer accepts no responsibility and the guarantee will not apply.
• Always unplug the appliance when you have finished using it and when
you are cleaning it.
• Do not use the appliance if it is not working properly or if it has been
damaged. In this case, contact an authorised service centre (see the list
in the service booklet).
• All maintenance other than cleaning and everyday upkeep by the cus-
tomer must be performed by an authorised service centre.
• Do not touch any moving parts (blades, etc.). FIG 3
• Do not touch the blades of the mixer shaft (C) even when it is stopped,
it is extremely sharp. FIG 3
• Handle the blades (E2, F2, G2, I3) of the choppers with care, they are
extremely sharp.
• Do not immerse the appliance, power cord or plug in any liquid.
• Ensure that long hair is tied back and that any scarves or ties do not
come into contact with the moving parts of your appliance.
• Do not leave the power cord hanging within reach of children.
• Do not allow children to use the appliance unless they are supervised.
• Do not leave the power cord close to or in contact with the hot parts of
the appliance, near a source of heat or a sharp angle.
• Do not use the appliance if the power cord or plug have been damaged.
To avoid all danger, have them replaced by an authorised service centre
(see the list in the service booklet).
• For your safety, only use spare parts and accessories that are approved
for your appliance.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
• If your appliance "jams" during processing, switch it off and check
that the accessory used is not overloaded with ingredients. Carefully
remove the ingredients obstructing the blades.
• Your appliance is equipped with a device to protect against over-
heating. If your appliance overheats, it will switch itself off. Leave
it to cool down for about 20 minutes then start using it again.
15
EN