Installing Batteries; Auto Power-Off Function - VOX Amplification amPlug2 Manual De Usuario

VOX amPlug 2 Owner's Manual
Thank you for purchasing the VOX amPlug 2 Headphone
Guitar Amplifier. To take full advantage of this product and to
ensure trouble-free operation, please read this owner's manual
carefully and use the product as directed.

Installing Batteries

cator becomes dark.
NOTE: Depleted batteries must be removed from the amPlug
2 immediately. If you leave them in, malfunctions such as bat-
tery leakage may occur. You should also remove the batteries
if you will not be using the amPlug 2 for an extended period
of time.

Auto Power-Off Function

amPlug 2 is equipped with an auto power-off function. If no
buttons or controls are used or there is no user input for ap-
proximately 30 minutes, the amPlug 2 automatically turns off.
NOTE: When the input level is extremely low or there is very
little change in the sound, the amPlug 2 may conclude that
there is no input. In addition, depending on the settings and
environment, the amPlug 2 may interpret noise as input, even
if the guitar is not being played.
Guided Panel Tour
3 4
2
1
1. Input plug: This is where you would connect your guitar.
Swivel the plug as shown in Fig. 1 (¬p.4). Adjust the plug
angle according to the guitar being used.
2. STANDBY/ON/MODE button, indicator: Hold down this
button for approximately one second to turn the amPlug 2
on or off. Pressing this button after the amPlug 2 has been
turned on switches the mode. The indicator lights up in a
different color depending on the mode.
Mode 1 (green)
Clean Pure Clean
Blues Clean
Lead
Boost 1
3. AUX jack (stereo): This is where you would connect an
external audio device. Adjust the playback volume on the
connected player accordingly.
Remove the battery compartment
cover. Insert two AAA batteries as
shown in the figure to the left. Be
sure to observe the correct polarity
when installing the batteries. If
you'll be using amPlug 2 for an ex-
tended period of time, we recom-
mend that you use alkaline batteries.
Replace the batteries when the indi-
5 6 7
8
Mode 2 (orange) Mode 3 (red)
Twin Clean Boutique OD
Crunch Lead
Boost 2 Boost 3
4. GAIN control: This adjusts the amp gain.
5. TONE control: This adjusts the tone.
6. VOLUME control: This adjusts the overall volume of
the amplifier.
7. FX button: This selects an effect. Each press of this but-
ton switches the setting in the following order: Chorus
¬ Delay ¬ Reverb ¬ Effect off ¬ Chorus ... In addition,
one of three variations for the selected effect can be
selected by holding down the FX button and pressing
the STANDBY/ON/MODE button. The variation is
indicated by the number of beeps produced when the
button is pressed.
8. PHONES jack: This is where you would connect
headphones, portable speakers, a mixer or a recording
device.
Caution
• When connecting amPlug 2 to external equipment
such as a mixer or recorder, turn down the volume to
the minimum position on your external equipment
before you connect amPlug 2 to it. After connecting it,
power-on amPlug 2 and then adjust the volume of your
external equipment accordingly.
• When disconnecting amPlug 2 from your guitar, you
must grasp amPlug 2 near the base of its Input plug. If
you grasp it at the end, you risk breaking amPlug 2.
• Disconnect amPlug 2 from
your guitar before leaning
your guitar against a wall or
laying it on the floor. If you
fail to do so, amPlug 2 or
your guitar may strike the
floor and be damaged.
Specifications
Power supply: two AAA batteries
Battery life:
11 hours / 17 hours (FX on / FX off, alkaline)
4 hours / 9 hours (FX on / FX off, zinc-carbon)
Dimensions (W x D x H):
86 x 38 x 31 (mm) / 3.39" x 1.50" x 1.22"
(minimum)
Weight: 40 g / 1.41 oz. (Not including batteries)
Included items:
Owner's Manual
two AAA batteries (zinc-carbon)
* Specifications and appearance are subject to change
without notice for improvement.
- 2 -