Tabla de contenido
Session
300 front panel
®
PIEZO SWITCH
7
The Piezo switch is an EQ specifically voiced to remove the "brittleness" that can be present when using a
Piezo pickup in an acoustic guitar. Consult your guitar owner's manual to determine the type of pickup pres-
ent in your acoustic guitar.
GRAPHIC EQUALIZER
8
These sliders provide precise tone control through the constant-Q, nine band equalizer. Each band may be
boosted or cut 15 dB.
NOTCH FILTER FREQUENCY CONTROL
9
This knob selects the frequency for the notch filter cut. The range is from 100 Hz to 2 kHz. This control
features a Peavey patent, FLS or Feedback Locating System. There are LED's surrounding the knob which
will light up as feedback is present. This allows the user to see a visual cue as to where the frequency of the
feedback is centered and move the pointer of the knob to that location.
NOTCH FILTER CUT CONTROL
10
This knob controls the amount of notch for the frequency chosen via the Frequency Control (9).
DIGITAL EFFECTS SECTION
11
Includes digital reverb, chorus and delay. A complete description of this section is found on page
21.
CHANNEL VOLUME CONTROL
12
These knobs control the master volume of channels 1 and 2.
CHANNEL III 1/4" INPUT
13
1/4" Instrument Input.
CHANNEL III INPUT SWITCH
14
This switch selects which input jacks are being utilized for Channel III. There is a 1/4" input on the front
panel and two RCA-type jacks on the rear panel for using outboard devices such as CD players, MP3 players,
drum machines, etc. For the best performance and lowest noise, this switch should be set to the front 1/4"
input when the RCA jacks are not being used.
CHANNEL III GAIN CONTROL
15
Controls the input level for Channel III.
CHANNEL III TONE CONTROL
16
Controls the tone of Channel III. Setting this control to "0" sets the EQ to flat. Turning clockwise progres-
sively increases the bass and treble.
HIGH FREQUENCY CONTROL
17
This knob controls the level of the ribbon high-frequency driver. Turning this knob clockwise will increase the
level of the ribbon driver.
CHANNEL BLEND CONTROL
18
This control pans between the Channel I and Channel II preamps. This control is beneficial when you have
the sound of the preamps how you want them, but need to make fine adjustments to the balance between
the channels. It is also very beneficial when using a guitar with both a Piezo and Mic output and you wish to
blend the 2 signals.
MASTER VOLUME CONTROL
19
Controls the overall volume of the amplifier.
18
Tabla de contenido
