Assembly; Use; Service & Maintenance; Hexagon Key - Worksite EP164 Manual De Instrucciones

EN
Your machine is double insulated;
therefore no earthwire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
reel always unwind the reel completely.

3. Assembly

Prior to mounting an accessory always
unplug the tool.
Assembling the handle

Fig. 2

The handle is suitable for either left or
right-handed use.
‡ Install the handle in such way that the holes
match the screwholes on the machine.
‡ Tighten the handle with the bolts and

hexagon key.

Assembling accessoires
Fig. 3
‡ Press the spindle lock (5)
‡ Screw and tighten the pad holder on the spindle
‡ Depress the spindle lock (5)
‡ Mount the polishing pad onto the pad holder.

4. Use

Always follow the safety instructions and
keep to the applicable regulations.
‡ Hold the machine away from the workpiece
when switch it on and off.
‡ Always first switch the machine off after use
before removing the plug from the socket.
Speed control
Fig. 5
The speed of the disc can be controlled with the
rotary knob on top of the handle.
8
2 . When using a cable
The higher the position, the higher the speed.
When using wax on the polishing pad do not start
at a high speed.
Switching on and off
Fig. 6
‡ This machine is equipped with a safety
switch.
‡ Start the machine by pressing the "lock off"
(B) button (to disengage the switch) and
switch on the machine (A).
Switch Off
Release the switch (A).
The polisher will continue to run after it is
turned off.
Only lay the machine down once the motor
has completely stopped turning. Do not put the
machine on a dusty surface. Dust particles can
penetrate the machine.
Never use the spindle lock to stop the
motor turning.
5. Service & maintenance
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate over a
long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon
proper machine care and regular cleaning.
Trouble shooting
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below:
1. Machine fails to operate.
‡ Power turned off.
‡ (Extension) cable damaged.
2. The elektromotor hardly reaches
maximum speed.
‡ The extension cable is too thin and/or too
long.
‡ The mains voltage is lower than 230 V.