Reggiani Scoop Instrucciones De Montaje página 5

CONNECTION OF TERMINAL BOARD
- Open the inspection flap with safety key to gain access to the terminal board
.
Standard wiring involves use of terminal R for the phase, terminal N for the
neutral and the use of the fuse for fixture protection purposes.
Fuse ratings:
Metal halide lamps
Metal halide lamps
Halide filament lamps
If necessary, adapt the wiring to application requirements. When making
connections, adopt materials and procedures in accordance with current safety
regulations.
Connect any ground plates to relative ground terminal at the base of the post.
Do not place the copper conductor in direct contact with the post.
TO REPLACE FUSE
- Disconnect from mains.
- Check for any abnormal conditions and remedy them before proceeding to
change the fuse with characteristics identical to prescribed ratings.
SECURE TO THE GROUND WITH ANCHOR BOLTS
(accessor y code 7190) - N.B. Before proceeding, check for correct
dimensioning of the components and post anchor base as well as for
compliance with current regulations.
- Insert the anchor bolts in the special mounting accessory. Make sure that the
threaded ends are correctly seated; adjust position of the nut if necessary.
- Place the so-obtained assembly in the formwork. Prepare the wireway and
thread the excess wiring through the central hole of the accessory. Then
proceed to grout up to the level of the top flat surface (see drawing).
- After the plinth has set, free the threaded ends of the anchor bolts, then
proceed with the installation and electrical connection of the post.
All Reggiani luminaires conform to LVD 73/23, EMC 89/336 and 93/68
EEC and are CE marked.
WEEE Luminaires are defined as Waste Electrical and Electronic Equipment (WEEE) and as such may
not be disposed of as solid urban waste. At the end of their life cycle, they must therefore be correctly
treated and disposed of as substances of concern for both the environment and human health due
to the presence of dangerous substances in the electrical and electronic components.
The user must therefore consign used luminaires to the distributor when purchasing an equivalent new
luminaire or, exclusively in the case of Italy, directly to Ecolight, the Consortium for the Disposal of Waste
Electrical and Electronic Equipment (Consorzio per lo Smaltimento degli Apparecchi di Illuminazione),
delegated by Reggiani S.p.A. Illuminazione, who will collect the equipment free of charge and delivery it
to the special collection facilities set up by the local authorities to recover, treat and dispose of WEEE.
The illegal or inappropriate disposal of said waste is punishable by economic and/or administrative
sanctions of the amount established by the law.
N.B. The free collection of a luminaire may be refused if there is a risk of contamination for the personnel
performing the service, if it is evident that the luminaire does not contain the essential components or if
it contains waste other than WEEE, or if the weight of the luminaire collected is more than double the
weight of the luminaire acquired.
In these circumstances, disposal is the responsibility of the holder.
SCOOP
70W (fuse 8 x 31,5 - 9 x 36 2A time delay type)
150W (fuse 8 x 31,5 - 9 x 36 4A time delay type)
(fuse 8 x 31,5 - 9 x 36 2A quick type)
5 ENGLISH