Preparation For Operation - GRAPHITE 59G401 Manual Del Usuario

MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY / SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Flat spanner
2. Hexagonal key
3. Transport case
CHANGE OF CUT DIRECTION
It is possible to set die holder (4) in four different positions rotated by 90°.
Loosen the die holder fixing nut (3) enough to rotate the die holder (4) (fig. A).
Rotate the die holder (4) clockwise or counter-clockwise by 90° around power tool axis. Make sure the
protrusion in die holder (4) fits well in the gear casing hole.
Tighten the die holder fixing nut (3).
MAXIMUM CUTTING THICKNESS
Maximum cutting thickness depends on processed material hardness.
This power tool allows for straight and deformation free cutting of sheets with following gauges:
Type of material
2
Steel 400 N/mm
2
600 N/mm
2
800 N/mm
Aluminium 200 N/mm
SETTING A GAP BETWEEN DIE AND PUNCH
It is necessary to set correct gap between die and punch depending on the metal sheet gauge.
Unscrew the die holder fixing nut (3) and remove the die holder (4) from the gear casing.
Remove unnecessary distance washers (fig. B).
Fix the die holder (4) in the gear casing.
Die holder must be fully inserted and matched with one of four protrusions.
SWITCHING ON / SWITCHING OFF
Before connecting to a power supply always check that power supply voltage matches rated voltage
on the label fixed on the power tool.
To switch on the tool – slide the switch (1) forward (towards head) and hold in this position.
For continuous operation – press front part of the switch button. Switch button will automatically
lock in the position for continuous operation (fig. C).
To switch the tool off – press rear part of the switch button (1), it will automatically slide backwards.

PREPARATION FOR OPERATION

Max sheet gauge
1.6 mm
1.2 mm
0.8 mm
2
2.5 mm
OPERATION / SETTINGS
– 1 pce
– 1 pce
– 1 pce
14