Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SAFETY
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury!
indicates a hazard which, if not avoided,
will result in death or serious injury.
indicates a hazard which, if not avoided,
could result in death or serious injury.
indicates a hazard which, if not avoided,
could result in minor or moderate injury.
NOTICE: addresses practices not related to
personal injury.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition. Replace missing or
damaged safety labels.
CALIFORNIA PROPOSITION 65 WARNING:
This product and related accessories
contain chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm.
2
1.
Read this manual carefully. Failure to follow these
Instructions could cause serious bodily injury and/or
property damage.
2.
Consult installer or licensed plumber for correct relief
valve. Install system according to local codes.
3.
Always test water from well for purity before using.
Check local health department for testing procedure.
4.
Before installing or servicing tank, BE SURE pump
electric power source is disconnected. Release all
water pressure before working on tank or system.
Release air pressure before removing cover flange.
5.
Install relief valve in pump supply line to tank, as close
to tank as possible.
6. BE SURE pump electrical circuit is properly grounded.
7.
Remove bleeder orifices, air volume controls or other
air charging devices in existing system.
8.
DO NOT USE tank as a surge suppressor.
Risk of explosion. To prevent possible
serious or fatal injury and/or damage to equipment,
system pressure must be less than 100 pounds per
square inch (PSI) (689kPa) under any circumstances.
Failure to follow instruction can result in tank blowup. If
system discharge pressure can exceed 100 PSI (689kPa),
install a relief valve capable of passing the full pump
volume at 100 PSI (689kPa).
Risk of freezing. Do not allow pump, tank,
or piping system to freeze. Freezing can severely
damage equipment and may lead to tank explosion and
serious injury. Allowing tank to freeze voids tank
warranty.
CL491 (11-04-19)
Tabla de contenido
