Start-Up Guide; Check The Package Contents; Set Up The Printer - DNP DS-RX1 Guia De Inicio Rapido

1. Check the package contents

Printer Unit

2. Set up the printer

1.Connect the power code and the USB cable.
Turn on the power.
※When you install the printer driver, do not
connect the USB cable
4. Set the paper into the printer.
Insert position 2
(Under the black paper guide)
7. Insert the paper under the black paper guide until the buzzer beeps
(approx. to the dotted line). Make sure to insert the paper straight.
③
9. Set the supply side of the ribbon to the printer
carefully to take out any slack. Insert the
protrusion of the core left side in the hole on the
printer, then set the right side to the holder of the
same color (white). Take up the ribbon slack by
rotating the ribbon on the supply side.

Start-up Guide

Power cord (＊)
Paper holder
Paper tray (＊)
2.Release the open lever, and open
the front cover.
5. Remove a paper fixed tape,
and insert the paper.
④
[Note] When the front cover is closed, the printer will run initialization(5 blank sheets will be fed out).
L spacer
CD (＊)
（＊）
♦Printer driver
♦User's manual
＊Items with the * mark may not be attached according to destination.
Open lever
Insert position 1
10.Close the front cover.
However, if you turn on the printer after set the paper, the printer does not run initialization.
Before using, please read "For Safe Operation"
Screw
Attatchment
illustration
3.Set a new roll of paper on the paper holders.
Please do not set gaps between the roll paper
and the paper holder.
6.Fit the paper to the proper position for each size.
L size and 2L size correspond to the line of L,
and PC size and A5 size correspond to the line
of PC.
①
8. Set the take-up side core of the ribbon to the
printer. Insert the protrusion of the core left side in
the hole on the printer, then set the right side to the
holder of the same color (yellow).
11.Set the paper tray to the printer.
Manuals (＊)
♦For Safe Operation
♦Start-up Guide
○
×
L PC
②