Bluetooth Operation - Trevi SB 8340 SW Manual Para El Uso Y La Conexión

ENGLISH
press the MUTE button (19) again.
Note:
- Some audio outputs which you connect the Sound Bar (like headphone output) can have its own volume
control: make sure you have set on the source device an adequate level audio output otherwise the Sound
Bar will sound even at maximum volume.
- If the sound played by the Sound Bar be distorted means that the input signal is too strong: lower the volume
of the Sound Bar or paid on a level audio source device output more low.
- In case of connection to a TV by headphone output, it may happen that the sound reproduced by the Soundbar
is low even at maximum volume; in this case try connecting the Soundbar to the audio-scart output using
an adapter (not supplied).
USB/SD CARD (TF CARD) INPUT
1. Insert a USB memory into the input (5) or an SD card into the input (6);
2. Turn ON the nit, it will automatically play the Music file inside the USB or SD Card;
3. Press(15) button on the remote control to momentarily stop playback. Press it again to resume playback;
4. Press 9 (16) or : (14) button on the remote control to select tracks.
AUX-IN
1. Plug in 3.5mm AUX cable;
2. Turn ON the unit, press (13) button on the remote control and select the AUX-IN input;
3. For proper playback sound refer to chapter VOLUME ADJUSTMENT AND MUTE FUNCTION.
OPTICAL INPUT
1. To use a digital optical cable (not included) to connect the OPTICAL input (8) to the digital optical output of your
TV or other source devices;
2. Turn ON the unit, press (13) button on remote control and select the OPTICAL input;
3. Adjust the volume using (18) Vol+ and (20) Vol- buttons.
Note:
- Some TVs or devices is necessary to enable the digital optical output.
- PCM digital audio must be set on the source device for playback from this input.

BLUETOOTH OPERATION

1. Turn on the unit; press (13) button on remote control to select the BLUETOOTH function;
2. The system automatically goes into search mode, if not press, for a few seconds, the UNPAIR button (21) on
remote control;
3. Activate the Bluetooth functionality on the external device to be paired;
4. Start the device search. At the end select the "SB 8340 SW" device;
5. Enter the password "0000" if required;
6. Press (15) button on remote control to start playback and the 9 (16) or : b14) button on remote control
to select tracks;
7. Press and hold for a few seconds UNPAIR (21) button on remote control to stop the active connection and pair
a new device.
EQUALIZER
The soundbar has a pre-set equalizer system, repeatedly press the EQ button (17) during playback to select the audio
dynamic that best suits the music style being played.
8
SB 8340 SW