Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The Switch of Clean Water Mode and Dirty Water Mode
Clean water mode to dirty water mode
Place the pump vertical to the flat ground, and step A of the base by double feet, as
shown in the Fig. D.
Hold the handle by hand and lift up the pump until it can't move.
Rotate the locating ring to the direction of "23mm" until it can't move as shown in the
Fig. E.
Dirty water mode to clean water mode
Flush the mud and sand on the pump before switching.
Rotate the locating ring to the direction of "1mm" until it can't move as shown in the
Fig. E.
Hold the handle by hand and lift down the pump until it can't move.
Hints:
Only when it is under clean water mode can the water in the area be drawn to the low-
est drawing level as shown in the nameplate.
Cautions:
Dry running damages the pump.
When it is under manual control mode, the pump must be watched.
Finish Running
When drawing water under low water intake, the pool water has been pumped off, and at
this time, unplug the plug of the power line and
then lift up the pump to a water container, unscrew the output connector and drain all
the water in the water tube into the container.
When it is under other working conditions except complete water draining, unplug the
plug of the power line directly from the socket.
Cleanness
Danger
Electric shock danger. Make sure all the plugs have been unplugged before all the
maintenance work.
Hints:
Dirt may deposit, which may cause the rotation of locating ring not smooth enough to
make the switch function of clean water mode and dirty water mode lose efficiency, so
the pump should be cleaned up thoroughly and regularly.
Tabla de contenido
