Care And Cleaning - PROFLO PF1812UWH Instrucciones De Instalación

UNDERCOUNTER INSTALLATION
Setting tool
Anchor
M arble
Foam padding
Cl amp
Apply sealant
Wood Anchor
screw screw
• C ut out the opening by carefully following the
pencil line traced from the template.
NOTE: The screws and anchors provided
should be used on countertops with a
minimum 1" (2.5 cm) thickness. For thinner
countertops, use appropriate anchors and
fasteners (not provided).
For Wood Countertops
• Mark and pre-drill the wood screw holes at
the locations shown on the template.
• Waterproof any exposed areas of wood.
For Marble/Stone Countertops
• Position the countertop upside down on foam
padding to protect the surface. Mark and drill
3/8" holes 5/8" (1.6 cm) deep at the
locations shown on the template.
• Use a setting tool and hammer to secure
the anchors.
For All Undercounter Installations
• If the countertop has not been installed,
install it at this time.
• Drill the faucet holes according to the faucet
installation instructions.
• Install the faucet to the countertop according
to the faucet manufacturer's instructions.
• Install the drain to the lavatory according to
the drain manufacturer's instructions.
N OTE: Do not use adhesives or adhesive
sealants.
• Apply a continuous bead of quality sealant
to the top surface of the lavatory rim where it
will contact the countertop.
CAUTION
Risk of persona l injury or
product da ma ge.
Handle with care. Product can break,
chip or cause injury if handled carelessly .
Get help lifting the lavatory .
• For marble countertops, install the lavatory
to the countertop with the clamps and screws
provided. For other countertop materials,
refer to the countertop manufacturer's
instructions for recommended fasteners.
• Position the lavatory squarely under the
cutout before tightening the clamps. Draw
the lavatory rim up against the countertop
until it is snug. Do not overtighten.
• Immediately wipe away any excess sealant
and fill any voids as needed.
• Allow the sealant to set for 30 minutes before
proceeding.
• C onnect and tighten the trap to the drain,
and complete the water supply connections to
the faucet according to the instructions
packed with the faucet.
• Run water into the lavatory and check for leaks.
• C lean up with a non-abrasive cleaner.
3

CARE AND CLEANING

• To keep your lavatory looking new, make sure
you rinse it out thoroughly after each use.
CAUTION
Risk of product da ma ge.
DO N OT use strong abrasive cleaners, as
they will scratch and dull the surface.
• Stubborn stains, paint, or tar can be
removed with turpentine or paint thinner.
4