Emptying The Waste Material Container; Care And Maintenance - Hilti DD-WMS 100 Manual De Instrucciones Original

6. Close the two catches.

6.4 Emptying the waste material container

1. Open the two catches.
2. Lift the top section of the appliance away from the water and waste material container.
3. Remove the filter bag. → page 17
4. Empty the waste material container.
5. Clean the water and waste material container.
6. Insert the filter bag. → page 16
7. Fit the top section of the appliance onto the waste material container.
8. Close the two catches.

7 Care and maintenance

7.1 Checking the prefilter
1. Remove the filter bag holder.
2. Check whether the prefilter is clogged.
3. If the prefilter is clogged, clean it with fresh water.
Note
Alternatively, a brush or compressed air can be used to clean the prefilter.
7.2 Checking the float level
WARNING! Risk of damage to the equipment or other property.
▶ Check and clean the water level monitoring system at regular intervals. Switch the product off
immediately if signs of damage are found.
1. Remove the filter bag holder.
2. Check that the float is free to move.
3. Clean the float if it does not move freely.
7.3 Checking the seal on the filter support
1. Check that the seal on the filter support is clean.
2. If the seal on the top section is dirty, clean it with a cloth.
3. Grease the seal.
8 Transport
8.1 Stacking toolboxes for transport
1. Raise the toolbox retaining bar.
2. Stack the toolboxes with their grips placed over the toolbox retaining bar.
Note
The toolbox retaining bar must project beyond topmost toolbox.
The maximum permissible additional load is 25 kg.
3. Attach the ratchet strap to the ratchet strap hook.
4. Use the ratchet strap to secure the toolboxes and prevent them slipping out of place.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
18 English
Printed: 12.06.2017 | Doc-Nr: PUB / 5306545 / 000 / 03
6
7
8
9