Idiomas disponibles
Idiomas disponibles
5 - Replace the rear flat seal (24) which is supplied with the spare 'oscillator assembly' and 'high voltage
generator'.
6 - Position rear plate (44).
Do not squeeze the cable between the rear plate and the gun handle.
7 - Position identification plate (41).
8 - Screw stop nut (2) then the 3 fastening screws (80).
9 - Tighten stop screw (2).
10 -Lock screws (80).
11 -Re-tighten needle stop (1).
COMPLY WITH INSTALLATION ORDER - CORRECT TIGHTENING IS REQUIRED.
Incorrect installation may cause product leakage in the electronic parts and damage
HIGH VOLTAGE CABLE ASSEMBLY REPLACEMENT
Removal
1 - Carry out operations 1 to 4 of generator and oscillator replacement.
5 - Unscrew 2 of the 6 screws (98) to separate green and red wires of the supply cable (34) from the generator
/ oscillator assembly (refer to view n°3).
6 - Put the generator /oscillator assembly aside.
7 - Remove screw (82).
8 - Loosen screw (84).
9 - Unscrew the air hose (36).
10 - Remove the 2 screws (85).
11 - Remove bracket (34) to come out the cable from the gun body by guiding it. Handle plate for fitting (86)
with care.
Installation
The high voltage cable is supplied with a guide wire (brass) mounted on each rope-thimble (refer to view n°4).
KREMLIN REXSON
them.
7
View n° 4
Doc. / Dok. 573.675.070
