Uline H-8992 Instrucciones De Ensamblaje página 2

ATTACHING TO WALL
DRYWALL
1. If attaching to wood studs, drill mounting pilot holes
using a drill with a 11/64" drill bit. Continue to step 2.
CONCRETE WALL
1. If attaching to cement wall, drill mounting holes
using a 5/16" drill bit roughly 2½" deep. Insert 60 mm
plastic anchors into pre-drilled holes.
2. Align brackets to pre-drilled holes and fasten bottom
three holes to wall using drill with Phillips head drill
bit and three M6 x 55 mm wall mount screws per
bracket. (See Figure 3)
Figure 3
3. Use a level on the brackets to ensure they are
leveled correctly before moving to step 4. Adjust if
needed.
4. Gently lift top of bracket to allow spring support to
fold down. Fold down spring supports to access top
three wall mount holes in brackets. Fasten to wall
using drill with Phillips head drill bit and three
M6 x 55 mm wall mount screws per bracket.
(See Figure 4)
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
5. With both brackets securely in the upright position,
place tabletop onto brackets leaving a 1/4" space
between end of tabletop and wall. This spacing
allows clearance for tabletop to properly fold down.
(See Figure 5)
6. Have another person hold tabletop in place. Using a
drill with a 10 mm socket attached, secure front two
holes of each bracket to underside of tabletop with
supplied M6 x 25 mm wood screws. (See Figure 6)
7. While another person supports the tabletop, gently
lift front of top to allow spring support to fold down
giving access to the two mounting holes located at
the back of the bracket.
Figure 5
1/4"
Wall
Figure 6
WARNING! Spring support holds bracket upright.
Ensure assistant is holding the tabletop during
these steps so that it does not collapse.
0321 IH-8992