Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ENGLISH
Maintain your chainsaw when not in use. Do not store
your chainsaw for any length of time without first
removing the saw chain and guide bar which should be
kept immersed in oil. Store all parts of your chainsaw in
a dry, secure place out of reach of children.
We recommend you drain the oil reservoir prior to
storage.
Be sure of your footing and pre-plan a safe exit from a
falling tree or branches.
Use wedges to help control felling and prevent binding
the guide bar and saw chain in the cut.
Saw chain care. Keep the saw chain sharp and snug on
the guide bar. Ensure the saw chain and guide bar are
clean and well oiled. Keep handles dry, clean and free
from oil and grease.
Kickback can be caused by:
Striking branches or other objects accidentally with a tip
of the saw while the saw chain is moving.
Striking metal, cement or any other hard material near
the wood, or buried in the wood.
A dull or loose chain.
Cutting above shoulder height.
Lack of attention when holding or guiding the chainsaw
while cutting.
Over-reaching. Keep proper footing and balance at all
times and do not overreach.
Do not try to insert into a previous cut. As this could
cause kickback. Make a fresh cut every time.
We strongly recommend you do not attempt to operate
your chainsaw while in a tree, on a ladder or on any
other unstable surface. If you decide to do so, be
advised that these positions are extremely dangerous.
When cutting a branch that is under tension, be alert for
spring back so that you will not be struck when the
tension is released.
Avoid cutting:
Prepared timber.
Into the ground.
Into wire fences, nails. etc.
Into small sized brush and saplings because slender
material may catch the saw chain and be whipped
towards you, or pull you off balance.
Do not use your chainsaw above shoulder height.
Ensure someone is nearby (but at a safe distance) in
case of an accident.
If for any reason you have to touch the saw chain, make
sure your chainsaw is disconnected from the mains.
The noise from this product can exceed 80 dB(A). We
therefore recommend you take appropriate measures
for the protection of hearing.
8
Safety of others
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a
person responsible for the their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Vibration
The declared vibration emission values stated in the
technical data and the declaration of conformity have been
measured in accordance with a standard test method
provided by EN 60745 and may be used for comparing one
tool with another. The declared vibration emission value may
also be used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons
regularly using power tools in employment, an
estimation of vibration exposure should consider, the
actual conditions of use and the way the tool is used,
including taking account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle in addition to the trigger time.
Warning symbols
The following warning symbols are found on your tool:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Do not use your saw in wet conditions or
expose it to rain.
Always wear head and eye protection.
Always wear ear protection.
Always wear eye protection.
Always wear non-slip safety footwear.
Tabla de contenido
