Unpacking And Assembly - EarthQuake Vector 26750 Manual Del Operador

UNPACKING AND ASSEMBLY

UNPACKING AND ASSEMBLING YOUR TILLER
1. Open top of carton and remove handlebar assembly.
2. Parts bag for VECTOR tiller contains:
2- Bolts M8 x 1.25 x 20 Hex Head
6- Bolts M8 x 1.25 x 25 Hex Head
6- Washers M8 8.4mm x 24mm x 2.2mm
6- Nuts M8 x 1.25
2- Middle Handlebar Straps
2- Hand Knobs
6- Bolts M6 x 1.0 x 12
6- Nylock Nuts M6 x 1.0
3. Remove machine from carton
4. Assemble the upper handlebar onto the lower handlebar
loop. Use the two (2) middle handlebar straps to connect the
upper handlebar to the lower handlebar loop. Put the M8 x
25 bolts through the six lower bolt holes from the outside in.
Put on six (6) washers and tighten with six (6) M8 nuts on the
six (6) bolts. Tighten the two (2) M8 hand knobs on the two
(2) M8 x 20 bolts in the upper most hole on each side of the
handlebar. (SEE FIGURES 1 AND 2) The two (2) upper bolts
and hand knobs can be used in one of three hole positions
for handlebar height adjustability. SEE FIGURE 3
M8 x 25 bolts
8
All manuals and user guides at all-guides.com
lower handlebar loop
washers
M8 nuts
FIGURE 1
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
IMPORTANT
THE RIGHT AND LEFT SIDES OF YOUR RO-
TOTILLER ARE DETERMINED FROM THE
OPERATING POSITION AS YOU FACE THE
DIRECTION OF FORWARD TRAVEL.
ENGINE IS SHIPPED FROM FACTORY WITH-
OUT OIL. YOU MUST ADD ENGINE OIL BE-
FORE STARTING ENGINE.
CAUTION
DO NOT TRY TO LIFT THE ROTOTILLER FROM THE
CARTON.
upper handlebar
M8 x 20 bolts
M8 x 25 bolts
lower
handlebar loop
Lowest Position
Highest Position
Operator's Manual
VECTOR™ Compact Tiller
L
M8 hand
knobs
handlebar strap
FIGURE 2
Middle Position
FIGURE 3
R