Tabla de contenido
Idiomas disponibles
Idiomas disponibles
90520380 Lopper w batt revised
properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting,
and any other conditions that may affect its operation. A guard or
other part that is damaged should be properly repaired or replaced
by an authorized service center unless otherwise indicated
elsewhere in this instruction manual. Have defective switches
replaced by authorized service center. Do not use chain saw if
switch does not turn it on and off. Do not operate a chain saw that is
damaged, improperly adjusted, or is not completely and securely
assembled. Be sure that the saw chain stops moving when the
trigger is released.
• Guard Against Kickback
WARNING: KICKBACK may occur when the nose or tip
of the guide bar touches an object, or when the wood closes
in and pinches the saw chain in the cut. Tip contact in some
cases may cause a lightning fast reverse reaction, kicking the
guide bar up and back towards the operator. Pinching the saw
chain along the top of the guide bar may push the guide bar
rapidly back towards the operator. Either of these reactions
may cause you to lose control of the saw which could result in
serious injury to user.
The following precautions should be followed to minimize
kickback:
(1.) Grip Saw Firmly. Hold the chain saw firmly with both hands
when the motor is running. Use a firm grip with thumbs and fingers
encircling the chain saw handles. Chain saw will pull forward when
cutting on the bottom edge of the bar, and push backward when
cutting along the top edge of the bar.
(2.) Do not over reach.
(3.) Keep proper footing and balance at all times.
(4.) Don't let the nose of the guide bar contact a log, branch, ground
or other obstruction.
(5.) Don't cut above shoulder height.
(6.) Use devices such as low kickback chain and reduced kickback
guide bars that reduce the risks associated with kickback.
(7.) Only use replacement bars and chains specified by the
manufacturer or the equivalent.
(8.) Never let the moving chain contact any object at the tip of the
All manuals and user guides at all-guides.com
8/27/07
10:57 AM
Page 3
guide bar.
(9.) Keep the working area free from obstructions such as other
trees, branches, rocks, fences, stumps, etc. Eliminate or avoid any
obstruction that your saw chain could hit while you are cutting
through a particular log or branch.
(10.) Keep your saw chain sharp and properly tensioned. A loose or
dull chain can increase the chance of kickback. Check tension at
regular intervals with the motor stopped and battery removed, never
with the motor running.
(11.) Begin and continue cutting only with the chain moving at full
speed. If the chain is moving at a slower speed, there is a greater
chance for kickback to occur.
(12.) Cut one log at a time.
(13.) Use extreme caution when re-entering a previous cut. Engage
ribbed bumpers into wood and allow chain to reach full speed before
proceeding with cut.
(14.) Do not attempt plunge cuts or bore cuts.
(15.) Watch for shifting logs or other forces that could close a cut
and pinch or fall into chain.
• Power Supply
Connect chain saw battery charger to correct voltage, that is, be
sure that the voltage supplied is the same as that specified on the
nameplate of the tool.
Additional safety instructions for the
Alligator
Lopper
TM
WARNING: Never use the tool above shoulder height. Always
position yourself out of the path of falling branches and debris.
WARNING: Do not use this tool to fell trees.
- Pre-plan a safe exit from falling branches and debris. Ensure the
exit route is clear of obstacles that would prevent or hinder
movement. Remember wet grass and freshly cut bark is slippery.
- Be aware of the direction that a branch may fall. Consider all
conditions that may affect the direction of fall, including:
- The intended direction of fall.
3
Tabla de contenido
