Tabla de contenido
Idiomas disponibles
Idiomas disponibles
90520380 Lopper w batt revised
Troubleshooting Section
If your Chain Saw does not operate correctly check the following:
Problem
Possible Cause
• Tool will not
• Battery not
start.
installed properly.
• Battery not
charged.
• Unit will not
• Battery not
charge.
inserted into
charger.
• Bar / chain
• Chain too tight.
overheated.
• Lubrication
needed.
• Chain is loose.
• Chain tension set
incorrectly.
• Chain tension set
• Poor cut
incorrectly.
quality.
• Chain needs
replacement.
• Unit runs but
• Chain installed
does not cut.
backwards.
• Oil is not
• Sawdust / debris is
getting to
accumulated under
chain.
sprocket cover.
All manuals and user guides at all-guides.com
8/27/07
10:58 AM
Page 14
Possible Solution
• Check battery installation.
• Check battery charging
requirements.
• Insert battery into charger
until red LED appears.
Charge up to 8 hours if
battery totally drained.
• Refer to "adjusting chain
tension" section.
• Refer to "chain oiling"
section.
• Refer to "adjusting chain
tension" section.
• Refer to "adjusting chain
tension" section.
Note: Excessive tension
leads to excessive wear
and reduction in life of bar
& chain. Lubricate before
each cut.
Refer to "replacing the
chain" section.
• Refer to sections for
installing and removing
chain.
• Remove battery, remove
sprocket cover. Clean out
accumulated sawdust / debris.
14
Tabla de contenido
