PROUSER CC-CA Manual Del Usuario página 9

Modified Sine Wave
5.2 Connecting the inverter with car socket (INC150N, INV150N,
INV300N and INV600N)
The inverter is connected via a plug connected to a 12V socket. The middle pin of the plug
must be connected to the position wire and the two side brackets of the plug must be
connected to the negative wire.
Caution
Make sure the plug is firmly connected in the socket. If the connection is loose,
the plug may heat up.
Caution
The rating of the socket, the supply cable and the fuse must be at most 15amps. Do not
put in a fuse with a higher rating.
Caution
Always check the rated power of device before connecting with car socket. Its rated
power can NOT be more than 100W.
5.3 Connecting the inverter with battery (INV300N, INV600N,
INV1000N, INV1500N and INV2000N)
To set up the inverter, connect the red cable to the positive pole (+) of the battery and
inverter, connect the black cable to the negative pole (-) of the battery and inverter.
Caution
Make sure the battery poles are clean when connecting the terminals.
Tighten the nuts and bolts to a torque of 12-13 Nm. Loose connections may cause
overheating.
9
Connecting the inverter