PROUSER CC-CA Manual Del Usuario página 11

Modified Sine Wave
Observe the following when using the device
If the battery voltage falls below 11V during operation, a warning tone sounds. If the battery
voltage falls further, the inverter switches off and the red error LED (fig. 1.5 page 2) lights up.
If the inverter overheats, it switches off – the red error LED lights up.
☞
If this happens, switch the inverter off with the switch.
When it cools down, you can use the inverter again.
When operating the inverter at a high load for lengthy periods, it is advisable to start the
engine in order to recharge the vehicle battery.
You can operate the inverter with the engine running or switched off.
However, do not start the engine while the inverter is switched on, since the power supply to
the cigarette lighters is disconnected during ignition.
Caution
Modified sine wave inverter could operate with most electrical device. Please
check with the manufacturer of the product you are going to use if it is
possible. For example there might be problems operating with precise
instrument, e.g. high precision research testing equipment, medical monitor.
USB port
Connect the USB external appliance to the USB port and switch it on. The USB port on the
power inverter provides a power supply of 5V DC for external USB devices.
Warning
The USB port on the power inverter is not designed for transferring data. Do
not connect memory sticks, MP3 player or similar data storage external
appliances. Do not connect any data transfer cable to the USB port.
11
Using the inverter