Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GENERAL SAFETY INSTRUCTIONS
Keep away from children
Always wear ANSI Z87.1 eye protection when operating or performing maintenance on this tool. Everyday eye glasses
are not safety glasses
Always wear hearing protection when operating this tool
Keep hands, loose clothing and long hair away from rotating end of tool
Anticipate and be alert for sudden changes in motion during start up and operation of any power tool
Keep body stance balanced and firm. Do not overreach when operating this tool
Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by
hand or against the body is unstable and can lead to loss of control
Do not operate this tool for long periods of time. Vibration caused by tool action may be harmful to your hands and
arms. Stop using any tool if discomfort, tingling feeling or pain occurs. Seek medical advice before resuming use
Stay alert. Do not use the tool while tired or under the influence of drugs, alcohol, or medication
Use only impact accessories. Non-impact accessories may break and cause a hazardous condition. Inspect accesso-
ries prior to use to ensure that it con tains no cracks.
Do not operate this tool in the presence of flammable liquids, gasses, dust, or explosive atmospheres
This tool is not insulated against electric shock, contact with a live wire will make exposed metal parts live
Always turn off the air supply and disconnect the air supply hose before installing, removing or adjusting any acces-
sory on this tool, or before performing any maintenance on this tool
Avoid unintentional starting. Be sure trigger is off before connecting to the air supply
For safety, top performance, and maximum durability of parts, operate this tool at 90 psig (6.2 bar / 620 kPa)
maximum air pressure at the inlet with 3/8'' (10mm) inside diameter air supply hose. Adequate air supply volume
is required for full power. Restrictions in the supply and volume will cause a drop in air pressure when the trigger is
pulled resulting in lower power
Do not use damaged, frayed or deteriorated air hoses and fittings
Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet fuel
Do not remove any labels. Replace any damaged label
Tool service must be performed by qualified repair personnel. When servicing, use only PROTO
erating
replacement parts. Use only lubricants recommended by PROTO
Do not use this tool at heights exceeding 6 feet (2m)
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other reproductive harm.
g or
Some examples of these chemicals are:
- lead from lead-based paints
- crystalline silica from bricks and cement and other masonry products
- arsenic and chromium from chemically-treated lumber
perating
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks
that are specially designed to filter out microscopic particles
Do not use the tool if the trigger does not turn the tool on or off
ximum
Accessories and tools get hot during operation. Wear gloves when touching them
Inspect anvils and hog rings prior to use. Missing or damaged items should be replaced before use
®
authorized, identical
®
3
Tabla de contenido
