Description Of The Artromot ® -Sp3; Description Of The Device Components - ARTROMOT SP3 Instrucciones Para El Uso

2. Description of the ARTROMOT
The motorized CPM device provides the
following passive motion to the ankle
joint:
plantar flexion / dorsal extension
50° / 0° / 40°
inversion / eversion
40° / 0° / 20°
It can be reconfigured for use on either
side and allows patients to exercise in
bed and while sitting on a chair.
Note!
To unambiguously represent the cur-
rent position of the CPM device, the
values for plantar flexion and inver-
sion are marked with the symbol "-"
both on the display and in this docu-
ment.
These are some of the
®
ARTROMOT -SP3 features:
- anatomically correct setup
- physiological movements
- programming unit for precise
adjustment of patient-specific
therapy values
- symbols for easy operation of the
programming unit
- chip card for storage of the
programmed therapy parameters
Biocompatibility
Those parts of the ARTROMOT
device that come into contact with the
patient when the device is used as in-
tended, are designed to fulfil the bio-
compatibility requirements of the
applicable standards.
2.1 Description of the
Note: Please fold out page 3!
1. Clamping levers to adjust the height
of the calf support assembly
2. Calf support assembly
3. Motor A (center of rotation for dor-
sal extension/plantar flexion)
4. Bracket for programming unit
5. Clamping lever to adjust the inclina-
tion of the carriage
6. Aiming pin for adjustment of the ro-
tational axis of the upper ankle joint
7. Footplate
8. Knurled screw for adjustment of the
footplate height
9. Knurled screw to adjust the foot-
plate to the leg length
10. Motor B
11. Footplate bracket
12. Thumbscrew to secure motor B on
the moving bracket for dorsal ex-
tension / plantar flexion
13. Bore hole to mount motor B to the
moving bracket for dorsal extension/
plantar flexion
14. CPM base
15. Moving bracket for dorsal extension/
plantar flexion
16. Power switch (ON/OFF)
17. Fuse cap
®
-SP3
18. Connection for power cord
19. Locking device to adjust the height
of the carriage
20. Perforation to set the height of the
carriage
21. Patient chip card
22. Programming unit
23. Nameplate
24. Connection for programming unit
42
®
-SP3
device components
1