Last Function Memory; Initialization Of The Microprocessor - Denon AVR-770SD Instrucciones De Operación

Tabla de contenido

Idiomas disponibles

TP search

Use this function to find RDS stations broadcasting traffic program (TP stations).

Set the input function to

"TUNER".

(Remote control unit)

Press the RDS button until

"TP SEARCH" appears on

the display.

(Remote control unit)

The main unit's display switches as follows

each time the RDS buttons are pressed.

Display

RDS SEARCH

PTY SEARCH

RT ON

TP SEARCH

This is the screen when operated.

Press the CHANNEL + (up)

or – (down) button TP search

begins.

(Remote control unit)

If no TP station is found with above operation,

all the reception bands are searched.

The station name is displayed on the display

after searching stops.

To continue searching, repeat step 3.

If no other TP station is found when all the

frequencies are searched, "NO PROGRAMME"

is displayed.

This is the screen when operated.

RT (Radio Text)

"RT" appears on the display when radio text data is

received.

When the RDS button is pressed until "RT" appears

on the display while receiving an RDS broadcast

station, the text data broadcast from the station is

displayed. To turn the display off, use the 0 and 1

cursor buttons on the remote control unit.

• This unit is equipped with a last function memory which stores the input and output setting conditions as they

were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

• The unit is also equipped with a back-up memory. This function provides approximately one week of memory

storage when the main unit's power switch is off and with the power cord disconnected.

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable

result, the initialization of the microprocessor is required by the following procedure.

NOTES:

• If step 3 does not work, start over from step 1.

• If the microprocessor has been reset, all the button settings are reset to the default values (the values set

Turning on the main unit's power from the standby mode without using the remote control unit

• Press the power switch on the main unit while pressing the 5CH/6CH STEREO button on the main unit's

This is the screen when operated.