Operating.instructions; Install.cartridge - Craftsman 47099 Instrucciones De Operación

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
1.
Wipe fittings clean before lubricating.
2.
Push coupler (1) onto fitting at slight
angle and then center coupler (1) on
the fitting
3.
Operate lever handle (3) to lubricate.
!
Notice
Do not damage seals of
equipment being lubricated by excessive
pressure or lubricant volume.
4.
After lubricating turn coupler (1) at a
slight angle to release grip of the
coupler jaws from the fitting.
!
Notice.
Failure to clean and inspect grease gun
will cause it to lose prime.
Air pockets in cartridge will cause lever
gun to lose prime.
W A R N I N G
Do not over pressurize grease gun.
Extreme pressure may cause nozzle
extension to burst.
Use only identical part nozzle exten-
sion replacement. See Service.Parts list
on page.6.
Keep hands clear of the extension
during operation of the grease gun.
Grease gun can develop high pressure
up to 10,000 psi (689 bar). Use safety
glasses and gloves for protection during
operation.
Failure to comply with this warning
may result in death or serious injury.
INSTALL CARTRIDGE
1
1.
While holding grease gun container
tube (6), loosen grease gun head (10)
two turns.
8
Large cap
2.
Pull T-handle (8) to extend follower rod
(5) fully and slide into slot.
3.
Unscrew container tube (6) from
grease gun head (10).
4.
Remove empty grease cartridge (if
present) from container tube (6).
5.
Remove large cap from top end of new
grease cartridge.
6.
Insert new grease cartridge top end
first into container tube (6).
7.
Remove pull tab from bottom end of
new grease cartridge.
8.
Screw container tube (6) back onto
grease gun head (10) and tighten.
9.
Pull lever handle (3) away from
container tube (6).
10. Pull back and remove follower rod (5)
from slot.
3
10
3
11. Turn T-handle (8) 90° and push into
container tube (6)
5
Grease cartridge
6
12. Loosen grease gun head (10) two turns
to expel air and retighten.
!
Notice
If grease does not come out of
coupler (1) after ten strokes of lever
handle (3), refer to Expel.Air.Pockets
section on page.5.
6
Pull tab

Capítulos

Tabla de contenido
loading

Tabla de contenido