Tools: Pencil, Screwdriver,
Measuring Tape, stud finder
Hardware: Four Anchors
Four Screws
Maximum total weight capacity for this product is 45 pounds (20.4 Kg).
Do not use cable to hang this set of Bracket from a single mounting point. Both key-holes must be
used to support the bracket on a wall using the provided hardware and following the below
instructions.
Mounting Instructions:
1) Before you get started with the below mounting steps, use a pencil to mark screw hole of 1
This is "Measurement A" Repeat the same for another key hole, which is "Measurement B". Repeat
nd
the same for 2
2) Next measure the distance between the brackets (measure parallel with wooden shelf). This is
"Measurement (C)."
3) Determine a desired mounting location. With the help of another person, hold the Bracket level
against wall at a desired mounting location. Use a pencil to mark out both sides of the hook. Place the
Bracket aside.
4) Replicate Measurement A&B of both brackets on the wall from the markings done in Step 1. The start
and end points of Measurement C will be the installation points for the mounting hardware. Use a
pencil & ruler to connect all the measurements. A horizontal line should be formed. Make the
necessary adjustments to ensure a horizontal installation.
5) Use a stud finder to look for wall stud in the desired installation points. If any of the installation
point aligns with stud, use provided metal screws only. If there is no stud, both the dry wall
anchors/metal screws are required.
6) If an installation point aligns with wall stud, use a Phillips screwdriver and secure a metal screw
directly into the installation point and into the aligned stud. Rotate the screw clockwise until the
screw head completely flush on bracket counter.
7) For installation point that do not align with a wall stud, use a Phillips screwdriver to insert the wall
anchor. Do not "push" or drive the anchor into the wall, it is designed to bore into the wall like a drill
bit. Slowly turn the anchor clockwise while applying pressure until the flange just touches the wall.
Again, using the screwdriver, insert a screw into the installed wall anchor and rotate the screw
clockwise until the screw head completely flush on bracket counter.
Care Instructions: To clean: wipe with a soft, dry cloth. Do not use abrasive or strong chemical
household cleaners. A household glass cleaner may be used for the Bracket
surfaces – spray the cleaner on a clean cloth first and then use the cloth to clean
the Bracket. Do not spray the cleaner directly onto the Bracket or frame surfaces.
bracket.
Thank you for your purchase
Stores | catalog |
The hardware included with this item is meant for
drywall or stud mounting only. If your walls are
made from concrete, brick or plaster, please
consult your local hardware store for assistance
in selecting the appropriate hardware.
Le matériel fourni avec
cet article est destiné au
montage sur gypse ou à
goujon uniquement. Si
vos murs sont en béton,
en brique ou en plâtre,
veuillez consulter votre
magasin de quincaillerie
local pour obtenir de
l'aide dans le choix du
matériel approprié.
www.westelm.com
Jordan Bracket
Mounting instructions
st
Bracket.