Wall Mounting - HIKVISION IDS-2SR8141IXS-AB-40X Guia De Inicio Rapido

No. Description
2 DC load
2 Installation
Before you start:
Check the package contents and make sure that the device in the package is in good condition and all the
assembly parts are included.
Notes:

For better detection effect, it is recommended to install the device in spacious area without blocking.

The tilt angle of the device should be less than 5°.

The recommended mounting height is 4 to 5 m.

DO NOT touch the lens cover directly by hand. The image blurs otherwise.

DO NOT drag the device with its waterproof cables; otherwise the waterproof performance is affected.

2.1 Wall Mounting

Notes:

For cement wall, you need to use expansion bolts to fix the bracket. For wooden wall, you can just use the
self-tapping screws to fix the bracket.

Make sure that the wall is strong enough to withstand more than eight times the weight of the device and
the accessories.
Before you start:
The bracket is not included in the package. You need to purchase one in advance.
Steps:
1. Install the bracket.
1) Drill four screw holes in the wall according to the holes on the bracket, and then insert four
expansion screws into the mounting holes.
2) Attach the bracket to the wall by aligning the four screw holes on the bracket with four expansion
screws on the wall.
3) Secure the bracket with four sets of hex nuts and washers.
2. Use the wrench to fix head cover on the bracket.
Note:
Make sure the radar module is directly facing the moving target.
No.
4
Figure 2-1 DO NOT Drag the Cables
Figure 2-2 Install the Bracket
5
Description
JQC-3FG Relay