Midwest Avian Adventures Hacienda Instrucciones De Montaje página 2

5 Position the Dome, created in Step 3, so the pegs in the corners line up with the
holes in the tabs of the Dome Sides.
6 While lowering the dome into the holes, line up the two single pegs that face down
from the top of the Dome into each of the flat tabs with the holes in the tabs in the top of
the Dome Sides.
7 When all the pegs are inserted correctly and secured, the locking tabs will "click."
Be sure all pieces are scurly fastened before proceeding.
Set the assembled Dometop (F) aside.
8 Locate the Main Base (A) and the four Casters (K.) On a solid surface, lay the Base
so the short legs are pointing up. Insert the Casters into the legs and with sufficient
pressure push the casters until they lock in place.
9 Turn the Base Assembly back over and locate the Front Panel (B.) Slide the Front
Panel onto pegs of one side of the Base assembly.
10 Locate the Back Panel (C.) Slide the Back Panel onto the pegs on opposite side
of the Base Assembly.
11 Locate the Side Panel with 2 food doors (D). Determine which side would be best
for you to have the 2 food doors. Slide the Side Panel over the metal tab at the bottom
of the Front Panel and Back Panel.
12 Insert and push the tabs at the top of the Side Panel into the sleeves on the top of
the Front and Back Panels.
13 Repeat Step 11 & 12 with the opposite Side Panel (E.)
14 Locate the Dometop (F) assembled earlier. Carefully lower the pegs on the
Dometop into the holes in the corners of the cage assembly. Push down making sure the
Dometop is totally inserted, locking all the panels together.
15 Locate the Bottom Grids (G) and the Bottom Pans (H.) The Pans can be inserted
in two different positions, depending on the use of the Bottom Grids.
Bottom Grids will be used: Slide the Bottom Grids in the rails just below the
front door. Slide the Bottom Pans immediately under the Bottom Grids.
Bottom Grids won't be used: For storage purposes, slide the Bottom Grids in
the lower rails. Slide the Bottom Pans in the rails above the Bottom Grids.
16 Open the feed doors on the side panels, and insert the Cup Holders (M) into the
tubes on the inside of the doors.
17 Locate the Feed Cups (L) and insert one into each of the Cup Holders.
E