Assembly And Operation - Worx WG168E Manual De Instrucciones

xINR18/65-y: Cylindrical lithium Ion battery
cells with max diameter of 18mm and max height
of 65mm; "x" represents a number cells serial
connected, blank if 1; "-y" represents a number of
cells paralleled connected, blank if 1.

ASSEMBLY AND OPERATION

NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for the cutting of grass and
weeds under bushes, as well as on slopes and edges
that can not be reached with the lawn mower.
WARNING! The charger and battery pack are
specially designed to work together so do not
attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery
pack connections because of an electrical failure and
hazard will occur.
WARNING! Always wear the eye protection.
Never lean over the trimmer head. Rocks or
debris can ricochet or be thrown into eyes and face
and cause blindness or other serious injury. When
operating unit, check for the following:
Wear eye protection and heavy clothing. Hold front
handle with one hand and auxiliary handle with
the other hand. Keep unit below waist level. Work
only from your right to your left to ensure debris is
thrown away from you. Without bending over, keep
line near and parallel to the ground (perpendicular
when edging) and not crowded into material being
cut.
WARNING! Make sure that line is fed out
before operation. Make sure motor is up
to full speed before trimming
WARNING! Use only 2.0mm diameter
cutting line. Other sizes of line will not feed
properly and will result in improper cutting head
function or can cause serious injury. Do not use other
material such as wire, string, rope, etc. Wire can
break off during cutting and become a dangerous
projectile that can cause serious injury.
Action
Assembly
Assembling the Main Handle
Assembling the Auxiliary Handle
Cordless Lawn Trimmer/Lawn Edge Trimmer
Assembling the Safety Guard
Removing or Installing Battery
Pack
Charging the battery pack
More details can be found in
charger's manual
Operation
Safety ON/OFF Switch
after the trimmer has been
switched off; wait until it has
completely stopped then lay down
the tool.
Three Speed Settings
Trimming
- Adjusting the Auxiliary handle
- Trimming
Edging
- Changing the tool into the
Edging mode
- Edging
adjusting the trimmer head
position.
Manually feeding the line
Replacing the trimmer line and
Spool
Manually winding the line
STORING YOUR GRASS
TRIMMER
Figure
Store in a dry place where the trimmer can be
protected from damage.
See Fig. A1, A2
MAINTENANCE
See Fig. B1, B2
Always check the product prior to being used
for any damage.
Never operate your product if it is damaged.
WARNING! The cutting
head continues to rotate
WARNING! Always remove
the battery pack before
Always remove the battery pack from
your trimmer after use.
See Fig. C1, C2,
C3
See Fig. D1, D2
See Fig. E
See Fig. F
See Fig. F
See Fig. G
See Fig. H1
See Fig. H2, H3
11
See Fig. H4
See Fig. I
See Fig. J1,J2,J3
See Fig. K1, K2,
K3, K4
EN