Releasing Regulator And Lighting Rod; Assembling Main Barrel/Hopper Assembly To The Cart; 9. Securing Main Barrel / Hopper Assembly To The Cart; Securing The Regulator Hose - Pit Boss PLATINUM KC COMBO PB1285KC Manual De Instrucciones

7. RELEASING REGULATOR AND LIGHTING ROD

Parts Required:
Main Barrel / Hopper Assembly (#9)
1 x
Installation:
• Take the Main Barrel / Hopper Assembly out with foam on its sides.
• Use the scissors to cut the cable tie which is under the Main Barrel / Hopper
Assembly to release the regulator and Lighting rod.
NOTE: Do not use knife to cut the cable tie because knife may damage
the regulator hose which may cause gas leaking.
8. ASSEMBLING MAIN BARREL / HOPPER ASSEMBLY TO THE CART
Parts Required:
1 x Main Barrel / Hopper Assembly (#9)
Installation:
• Use a second person to lift the Main Barrel / Hopper Assembly then seat it
to the pre-assembled cart.
NOTE: The regulator needs to be put inside the cart and the lighting rod
keep outside of the cart, the hose of the regulator needs to go through
the hole in the Front-Right Leg.

9. SECURING MAIN BARREL / HOPPER ASSEMBLY TO THE CART

Parts Required:
Main Barrel / Hopper Assembly (#9)
1 x
Screw (#A)
16 x
Installation:
• Mount the Main Barrel / Hopper Assembly to the pre-assembled cart.

10. SECURING THE REGULATOR HOSE

Parts Required:
1 x Regulator Hose Retainer (#E)
Screw (#C)
1 x
Installation:
• To avoid the lighting rod from falling on the ground, put the end of the
lighting rod on the step screw as shown in illustration.
• Use Regulator Hose Retainer to fix the regulator hose then use M5x12 screw
to mount the Regulator Hose Retainer to Front-Right Leg.
7
9
8
9
10
1
2
3
11