Cognex In-Sight 8000 Serie Manual De Instrucciones página 13

Connect the Ethernet and Power
The vision system's PoE connector provides the Ethernet connection for network
communications and supplies power to the vision system. The following steps
illustrate how to connect the vision system to the In-Sight CIO-MICRO I/O module. If
the CIO-MICRO I/O module is not used, a third-party PoE injector or a PoE switch
must be used to supply power to the vision system.
Note: The CIO-MICRO I/O module does not support 1000 BaseT pass-
through operation. If 1000 BaseT operation is required, you must connect an
RJ-45 LAN cable from a Gigabit PoE switch to the I/O module's LAN port and
connect the vision system's Ethernet cable to the Gigabit PoE switch.
Connect the Power Wires
CAUTION: Never connect the I/O module to a power source other than
24VDC. Any other voltage creates a risk of fire or shock and can damage the
hardware. Do not connect the 24VDC power source to any terminals other
than the 24VDC + and – power terminals.
1. Verify that the 24VDC power supply is unplugged and not receiving power.
2. Use a screwdriver to loosen the I/O module's power terminals (labeled
24VDC + and –).
3. Insert the 24VDC + and – wires (16 - 22 AWG, solid or stranded wire) from
the power supply into the 24VDC + and – terminals on the I/O module.
4. Tighten the screw terminals with the screwdriver to secure the wire leads in
the terminal block; the maximum torque is 0.1921 Nm (1.7 in-lb).
12