Software Updates - Pentair PENTEK INTELLIDRIVE PID10 Manual De Instalación Y Operación

Software Updates

NOTE: If using the information at https://www.pentair.com/en/brands/pentek/pentair-pentek-intellidrive-software-
update.html, please note that some internet browsers need to be refreshed to show the most current software files.
Please press Ctrl+F5 to refresh the webpage to verify that it is displaying the latest data.
To determine whether you need to update, compare the software version number
in your PENTEK INTELLIDRIVE
software version number currently loaded on your drive, press the password key on
the keypad, enter your password, and press Enter. Next, press the Main Menu key
followed by the up arrow key until SW Update is displayed, press Enter. The bottom
row of information indicates your existing software version. If the version number
you plan to install is higher than what is currently on the drive, an update is in order.
Please follow the directions below to update your software.
IMPORTANT: Read all safety instructions in the PENTEK INTELLIDRIVE
updating your drive.
Downloading Software to the SD Card
1. Before downloading new files from www.sta-rite.com/PIDupdate, verify that the SD card is empty.
2. Using the links above, download the AOC and MOC files to the SD card.
NOTE: SD cards are typically used in digital cameras and can be purchased in the electronics/camera section of most
retail outlets. Minimal storage space is needed for these files. Cards as small as 1GB have more than enough space.
Use only standard size SD cards; micro and mini SD cards will not work.
Updating Software on the Drive
1. Before moving forward with the software update, make note of the set up parameters used in the drive.
2. Remove power from the Intellidrive. Confirm by seeing text and light disappear from keypad. Power is normally
removed using a switch in the breaker box or switch in the fuse box.
3. Remove the plastic guard from the SD card slot (see picture below for location). This is simply a plastic insert that
protects the terminals in the card slot.
4. Insert SD card into the slot in the drive.
5. Reapply power to the drive.
6. Using the password, unlock the drive.
7. Press the Main Menu key, press the up arrow key until SW Update is
displayed and press Enter.
8. Set the parameter "Software Update" to "Enabled" by pressing enter
to "highlight" the word Disabled. Press the up arrow key to change
the parameter to Enabled. Press enter to "save" the change (the word
"Enabled" will no longer be highlighted when saved).
9. Remove power from the IntelliDrive. Confirm by seeing the text and
lights disappear from keypad.
10. Reapply power to the drive.
11. Wait while software updates. The screen will remain blank for about 90
seconds while this happens. When text reappears software upload is complete.
12. When the startup guide appears, enter data as prompted. See Intial Startup section of this manual as needed.
13. In the main menu go to the parameter group "SW Update" and press Enter.
14. Verify parameter "Software Update" now displays "Disabled".
15. Verify software version shows the version you intended to install.
16. Change other setup parameters using the previously recorded notes.
17. Remove power from the IntelliDrive. Confirm by seeing the text and light disappear from keypad.
18. Remove SD card.
19. Replace plastic guard. This helps protect the terminals inside the slot from corrosion, etc.
20. The software update is complete.
PN957 (3/23/20)
against the software you plan to install. To find the
®
Installation and Operations Manaual before ®
23 23