Kohler K-3145 Guia De Instalacion página 3

Sink
Sink Outline
Countertop
Trace the outline of the sink on
the countertop with a pencil at the
desired installation location.
1. Preparation
WARNING: Risk of personal injury. Metal surfaces are sharp
and can cause severe cuts. Use gloves and handle sink edges
carefully.
For new installations:
Carefully place the sink upside down on the countertop in the
desired position. Be careful not to damage the sink finish.
Make sure the sink will not interfere with the cabinet.
Trace the sink outline onto the countertop. Do not cut along the
outline.
For existing installations:
Carefully lift the old sink out of the countertop.
Compare the existing cut-out to the required cut-out size.
If needed, enlarge the cut-out hole according to the directions for
new installations.
For all installations:
Draw a line 1/4" (6 mm) inside the sink outline.
Before cutting, measure the cut-out line you just drew and
compare it to the overall sink dimensions. The cut-out should be
1/2" (1.3 cm) smaller than the overall sink dimensions.
Kohler Co.
1/4"
(6 mm)
Pilot
Hole
Create a second line 1/4" (6 mm)
in from the original sink outline.
3 1013270-2-E