Care And Maintenance - Rowenta PURE AIR GENIUS PU3080 Manual Del Usuario

• Indication of air quality
Air quality indicator (12) is located at the front panel (C) of the appliance. The 3 LED will indicate the air quality
level:
Air Quality
Excellent
Slight pollution
Moderate pollution
High pollution
Extreme pollution

CARE AND MAINTENANCE

Before performing any maintenance work, switch off the air purifier using the on/off button (1).
Use a damp cloth to clean the surface of the product.
Important: Do not use any abrasive materials, as these may damage the surface of the product.
Frequency of cleaning/replacing the filters :
Filter
Pre filter
2in1 Active Carbon & Allergy+ filter
NanoCaptur+ filter
These figures are based on tests in which the air purifier is used for 8 hours per day in quiet mode.
You may need to replace the filters more often depending on the air quality and how often the air purifier
is used. The filter replacement indicator (7)
will receive a notification on your mobile application. To replace the filters, please refer to the section
"Disassembling / Reassembling filters".
Important! When the filter replacement indicator (7)
order to know which filter has to be replaced. If two filters must be changed, please change them one by one.
Change the second filter only after changing the first one and after resetting the first filter.
• The pre-filter can be cleaned with a vacuum cleaner or rinsed in water.
Important: Resetting the filter
After replacing the filter, press the mode button (2)
Performing a force reset:
If you replace a filter before the end of its lifespan, press the mode button (2)
filter settings.
Caution :
If the granules become "white opaque", filter needs to be removed from the purifier until the granules
become transparent again.
If the opaque aspect persists, filter need to be changed.
If the granule become "crumbly", filter need to be changed.
The appliance efficiency can be reduced if the pre-filter is not cleaned regularly.
Never use a pre-filter that is still damp.
The pre-filter is the only filter which can be re-used and washed with water. The 2in1 Active Carbon & Allergy+ filter
cannot be cleaned and re-used. Never wash with water. The 2in1 Active Carbon & Allergy+ filter must be replaced
after the end of its lifespan. For optimum performance of the appliance, only use filters provided by Rowenta. If
the Nanocaptur+ filter granules become opaque white or/and crumbly, the filter needs to be changed.
Please note: certain filters may emit a temporary slight odour, due to the transport and storage conditions.
This odour will vanish and is not dangerous for people.
8
Air quality indicator color
Blue
Green
Yellow
Orange
Red
Clean/replace
Clean
Replace Every 12 months
Color changing (see
color chart on filter)
Replace
or every 12 months in
case of no saturation.
will turn on when the filters need to be replaced and you
turns on, please check on the mobile application in
for 3 seconds to reset the filter settings.
Frequency
Every 2 months
for 3 seconds to reset the
Filter codes
XD6231
XD6082