Features; Package Contents; Wiring; Edid Management - LEGRAND C2G30017 Manual Del Usuario

HDMI HDBaseT + VGA , 3.5mm, RS232, and IR over Cat Extender Dual Gang
Wall Plate Transmitter - 4K 60Hz

Features

HDMI and VGA inputs AV switching transmitter.
•
Supports automatic switching.
•
HDMI input up to 4K@60Hz (YUV 4:2:0) and HDCP 2.2, VGA input up to 1920x1200@60Hz.
•
Via a Cat 6a/7 cable, transmits 4K@60Hz (YUV 4:2:0) up to 40m and 1080P@60Hz signal
•
up to 70m.
Via a Cat 5e/6 cable, transmits 4K@60Hz (YUV 4:2:0) signal up to 35m and 1080P@60Hz
•
signal up to 60m.
Supports RS232 and IR pass-through over HDBaseT.
•
Supports PoC PD to receive power from an HDBaseT receiver with PSE module.
•
Can be powered by local DC 12V power supply and share power with near device via the
•
3-pin phoenix power out connector.
Independent DIP switch provided for VGA EDID management.
•
HDMI input EDID is copied from HDBaseT receiver.
•

Wiring

Warnings:
Before wiring, disconnect the power from all devices.
•
During wiring, connect and disconnect the cables gently.
•
Steps for device wiring:
1. Connect HDBT: Connect HDBT OUT of the transmitter to HDBT IN
of an HDBaseT receiver via a Cat 5e/6/7 cable.
2. Connect an HDMI display to the receiver.
3. Connect a power adapter to the receiver.
4. Connect a power adapter to the transmitter (If the receiver includes
PSE module, it can send power to the transmitter and no additional
power adapter is required at transmitter side).
5. Connect the video sources to the transmitter.
6. Power on all attached devices.
7. Select a desired video source through automatic or manual
switching function.

Package Contents

•
•
•
•
•
•

EDID Management

The transmitter equips a 3-pin DIP switch on front panel for EDID
configuration of VGA input.
By default, the EDID switch is set in "010" position. To configure EDID
for VGA input, refer to the following table:
1
0
Note:
HDMI input EDID is copied from HDBaseT receiver.
•
After the EDID is changed, please re-plug the VGA cable or restart
•
the device to take effect.
3
1 x Wall Plate Transmitter
1 x Wall Plate Plastic Panel (2‐Gang US,
with Screws)
1 x Phoenix Male Connector (3.5mm, 3 Pins)
3 x Phoenix Male Connectors (3.5mm, 2 Pins)
4 x Mounting Screws
1 x Manual
(us) (us)
(us)