Features; Package Contents; Mounting Bracket Installation; Troubleshooting - LEGRAND C2G30014 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

HDMI Ultra-Slim HDBaseT + RS232 and IR over Cat Extender Box Transmitter - 4K 60Hz

Features

Bi-directional Power over Cable (PoC), when transmitter or receiver is plugged in to power,
both sides are powered on
Extend 4Kx2K at 60Hz (4:2:0) up to 130ft and 1080p at 60Hz up to 230ft with Cat 6a/7 cable
Extend 4Kx2K at 60Hz (4:2:0) up to 115ft and 1080p at 60Hz up to 200ft with Cat 5e/6 cable
HDMI 1.4 with 4K at 60Hz, 4:2:0, 8bit and HDCP 2.2 compliant
Supports bi-directional IR and RS232 pass-through

Mounting Bracket Installation

Note: Before installation, please ensure the unit is disconnected from the power source.
1. Choose a suitable location for mounting bracket installation.
2. Position and install the mounting brackets of the transmitter with the two mounting
screws provided.
3. Repeat step 1 for the receiver.
4. Mount and secure the transmitter and receiver to a surface or a suitable location
respectively with mounting screws.

Troubleshooting

1. No Power
Ensure the power is on.
Ensure you use the power adapter provided in the package.
2. No Picture or Video Flash
Ensure all devices are on, and all cables are connected properly. Ensure all the cables' length are within the maximum distance.
Ensure all the LED indicators are normal.
Try connecting source to display directly, to ensure they work properly.
Ensure the input resolution is supported by the device.
Ensure the input resolution is within 4K@30Hz when Dolby vision signal is input.
3. Weak or Not Working IR Signal
Ensure the devices support IR control (not Bluetooth/WIFI).
Ensure you use the IR cables provided in the package.
Pay attention to the control angle and distance (chart to the right).
IR Cable
Suggested Angle
Distance (Max)
3

Package Contents

1 x Transmitter
1 x 18V 1A Power Adapter
1 x IR Emitter
1 x Broadband IR Receiver (30-50 KHz)
2 x Double sided tape for IR Emitter
and Receiver
1 x 3.5mm 3-Pin Phoenix Connector
2 x Mounting Bracket (with screws)
1 x Manual
IR Emitter
IR Receiver
30cm
8m
(us)
(us)
(us)
Tabla de contenido

Solución de problemas

loading

Tabla de contenido