Product Overview; Front Panel; Rear Panel - LEGRAND C2G30017 Manual Del Usuario

HDMI HDBaseT + VGA , 3.5mm, RS232, and IR over Cat Extender Dual Gang
Wall Plate Transmitter - 4K 60Hz

Product Overview

Front Panel

1
2
3
F P D
RONT ANEL ESCRIPTION
1 VGA In VGA input. Connect to a VGA source.
2 VGA Audio Audio input embedded with VGA input.
3 HDMI In HDMI input. Connect to an HDMI source.
4 Input Selection LEDs LED On: Corresponding input channel is selected.
On: HDCP protected content is being transmitted.
5 HDCP LED Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
6 Link LED
Off/Blinking: No HDBT link or link error.
7 Select Input selection button
4 5
6
Transmitter
7
8
9

Rear Panel

8 IR Sensor Receives IR signal from IR remote.
EDID Switch for VGA EDID management. For more
9 EDID
information, see EDID Management section.
R P D
EAR ANEL
10 HDBT Out HDBaseT Output. Connect to an HDBaseT receiver.
11 Power In For local DC 12V input.
For DC 12V output when the "Power In" port is connected
12 Power Out to local power supply. If the transmitter is powered by
PoC, this port doesn't output power.
13 RS232 For RS232 pass-through.
IR signal output. Connect to an IR emitter using the 2-pin
14 IR Out
phoenix connector provided.
2
Transmitter
10
11 12 13 14
ESCRIPTION
(us)
(us)