Installation Guide - Ergomotion Motion Air El Manual Del Propietario

installation guide

installation guide installation guide
Always use two people when setting up the base, moving or flipping the base.
STEP 1
Always use two people when setting up, moving or flipping base .
Remove the base from the carton and unfold the base so that the bottom
side is facing up .
Fig.A2
Fig.A1
STEP 2
Cut and remove all binding straps . Set the
packaged items aside .
STEP 3
Remove the Pins and Clips that are secured to the base (refer to Fig .C1) so
that you may attach the corresponding brackets and motors .
Fig.C1
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
8
Fig.B1
Fig.C2
STEP 4
a . Locate the Head Motor Bracket
(GREEN) . Slide the bracket into place
over the bolt on the frame shown in
Fig .D1, aligning the "H" holes with the
corresponding head bracket holes on
the base (Fig .D2) .
b . Slide a Pin through the Head Motor
Bracket holes that you aligned in Step
4a . Then secure the Pin with a Clip .
Fig.D1
Fig.D2
Fig.D3