Honeywell SV2 Serie Instrucciones De Instalación

SV2 Series Valve Programming Tool
HMITOOL-000
INSTALLATION INSTRUCTIONS
INTRODUCTION
This document provides installation and wiring instructions
for the Honeywell SV2 Series valves Human Machine
Interface (HMI) display. Other applicable publications are:
– 32-00018, SV2 Series Valve Installation Instructions
– 32-00029, SV2 Series Valve User Manual
– 32-00031, HMI/PC Tool User Manual
SPECIFICATIONS
Electrical Ratings:
Input Voltage: 18-30VAC (24VAC nominal), 50/60Hz
Input Current: 500mA max
Power consumption: 12W max
Operating Temperature Range:
-4 to +158 °F (-20 to +70 °C)
Storage/Shipping Temperatures:
-22 to +176 °F (-30 to +80 °C)
Humidity:
Max 90 % relative humidity continuous, non-condensing
Enclosure Rating:
IP20 / NEMA 1
Approvals:
FCC Part 15, Class A Digital Device
Underwriter's Laboratories, Inc. (UL) (cUL) Component
Recognized (for non-continuous operation):
File Number MH17367 (MJAT2.MJAT8).
Canada: ICES-003
Ports:
(2) RS-485 ports (COM 1 and COM 2)
(1) USB port
Number of Connected Valves:
Up to 8 valves wired in daisy chain fashion to a single port.
Mounting:
Flush front or behind mounted into a panel cutout.
Dimensions:
See Fig. 1.
SAFETY FEATURES
The HMITOOL display contains software that incorporates
many features that are designed to guide you safely
through the commissioning process. Safety, however, is your
responsibility.
Read all documentation carefully and respond appropriately
to all fault and warning messages.
WARNING
Explosion Hazard.
Improper fuel/air configuration can cause fuel
buildup and explosion.
Improper user operation may result in PROPERTY
LOSS, PHYSICAL INJURY or DEATH.
Installing and using the HMI display to setup or
change parameters must be attempted
and experienced combustion service technicians.
This device must be setup according to all applicable
national and local codes, ordinances and regulations.
only by trained
32-00030EFSP-05