Shure Microflex MX200 Serie Guia Del Usuario página 13

NOTES:
1. All resistors1/10 Watt, 1%, 0805 unless otherwise specified.
Electrolytic capacitors shown in µF, ±10%, 50V or more, unlss
2.
otherwise specified.
3. The following symbols denote:
A.C. Voltage A.C. Voltage, Mic Off
D.C. Voltage
D.C. Voltage, Mic Off
(+) / (–) indicate A.C. polarity relative to input test
signal.
4. All voltages measured with input driven by a 0.1 Vrms, 1kHz
signal through the test circuit shown below. The test circuit is
powered by a standard 48V phantom power supply con-
nected to J2, with a 1 kohm load across J2 pins 2 and 3. A
Shure M367 mixer or equivalent, with 48 V phantom power
switched on, supplies the required power and load.
SCHÉMA DE CÂBLAGE DU MICROPHONE
DIAGRAMA DE ALAMBRADO DEL MICROFONO
Printed Clrcuit Ground
Case Ground
PREAMPLIFIER SCHEMATIC DIAGRAM
SCHÉMA DE CÂBLAGE DU PRÉAMPLI
VORVERSTÄRKER–STROMLAUFPLAN
DIAGRAMA ESQUEMATICO DEL PREAMPLIFICADOR
SCHEMA CIRCUITALE DEL PREAMPLIFICATORE
FIGURE 8 S ABBILDUNG 8 S FIGURA 8
FET
86E8958
MIC
ELEMENT
MICROPHONE WIRING DIAGRAM
R27
R1
100
100
220 pF
220 pF
J1–1
MIKROFONSCHALTPLAN
SCHEMA CIRCUITALE DEL MICROFONO
13
R2 R28
100 100
J1–3
J1–2
J1–1 SHIELD BLINDAGE WEIß/SCHILD
BLINDAJE SCHERMATURA
J2–2 RED ROUGE ROT ROJO ROSSO
J2–3 BLACK NOIR SCHWARZ
NEGRO NERO