Commercial Electric 55701191 Guía De Uso Y Cuidado página 2

6. Plug one end of the power cord/linking cable (C) into the receptacle at the end of the shop light (A). Insert the other end of
the power cord/linking cable (C) into the electrical plug adapter (B), and then
plug the electrical plug adapter (B) into an electrical outlet.
7. Plug the plug end of the power cord into the AC120V, 60Hz socket, turn on the switch of the lamp body, and it will work normally.
CAUTION: when suspension mounting, make sure the light fixture is located directly below the electrical outlet. Excess
cord should be secured to the mounting chain (AA) with the cable tie (not included).
contInuous InstallatIon
Multiple light fixtures can be connected, up to a maximum of seven 40 in. shop lights or 280 total watts. Only the first light
fixture needs to be plugged into an electrical outlet.
1. Connect each additional fixture using either the linking cable (C) or end-to-end connector (D). when using the linking cable,
the maximum distance between two light fixtures is 5 ft.
2. For best results, fully insert the linking cable (C) or end-to-end connector (D) into the receptacle in the end of the shop light.
WARNING: RISK OF ELECTRIC SHOCK. Disconnect power to the shop light before linking additional shop lights. If the
receptacle on the end of the shop light is not used to link to another fixture, the receptacle needs to be closed by the end
cap. Do not touch live parts inside the receptacle.
lIgHt DIstrIButIon
B
AC 120V
60Hz
C
-120
-90
-60
aVerage BeaM angIe ( 50%) :120.0 Deg
C
-
o
D
-/+180
-150 -150
0
300
600
900
1200
-30 -30
0
2
-
o
AA
A
-120
-90
-60
AA
A
End cap