Locking The Safe; Selecting A Location - Uline H-8939 Guia De Inicio Rapido

ENTERING SECURITY CODE
1. After opening electronic safe (with the preset factory
code of 1-5-9-#), locate the small red button on
inside of door (near hinge).
2. Press red button and release it; user will hear a beep.
The yellow light on faceplate will activate and stay
on for a period of time that should allow user to
enter code. Code can only be entered while yellow
light is on.
3. With the door open and the yellow light on, enter
personal security code, which can be three to eight
digits long, and confirm new code by pressing the
asterisk symbol " * " on the electronic touch pad.
Before closing door, try new security code to ensure
lock releases handle so it can turn and retract the
live-action bolts.
NOTE: Do NOT shut door until CONFIRMING new
security code has been entered correctly.
4. If code fails, go through steps 1-3 again. If code
works successfully, record combination in a secure
place, away from children, not inside the safe.
Close and lock the safe.
5. When opening the safe in the future, enter security
code user has set followed by the "#" symbol.
6. If the incorrect security code is entered three
times, an automatic lockout will take place for 20
seconds before user can enter code again. Safe will
continue to beep (if sound is on) during the lockout
period.
7. If the incorrect security code is entered three
additional times, there will be a five-minute lockout
before the code can be tried again. Safe will
continue to beep (if sound is on) during the lockout
period.

LOCKING THE SAFE

To lock the safe, close the door and rotate the handle
counterclockwise until it stops. If the handle is not turned
until it stops, the locking mechanism will not lock.
NOTE: Because the locking mechanism is
deactivated for approximately three to six
seconds after the combination is entered, wait
a minimum of six seconds from the time the
combination is entered to lock the safe.
PAGE 2 OF 9
USAGE CONTINUED
TURNING THE KEYPAD SOUND OFF/ON
Turn off the "Beep" sound of the keypad by entering the
code *
To turn the "Beep" sound on, enter the code

SELECTING A LOCATION

1. The safe must be mounted to the floor. For optimal
safety and security, the safe should be installed
adjacent to a side wall with minimal space on either
side of the safe and in an isolated, dry and secure
area.
2. The safe should be flat against the wall and floor.
Remove the baseboard if necessary.
SECURING THE SAFE
1. To secure safe to the floor, it will first be necessary
to drill pilot holes through the fire insulation in the
floor of the safe. First, place the safe in the desired
location. Lift the bottom carpeting up to find the
two hole locations marked on the floor insulation.
Drill holes through the insulation using the same
diameter drill as the diameter of the mounting
hardware.
-6-3-3.
CAUTION! Children should not play with or
around the safe at any time.
CAUTION! The safe must be secured to the
floor. Use the hardware provided or consult
Uline Customer Service at 1-800-295-5510
for fastening hardware for your particular
mounting surfaces.
CAUTION! This safe must be mounted to the
floor. Failure to do so will compromise the
safety and security of the safe.
IMPORTANT! The fasteners must completely fill
the hole drilled into the insulation. (See Figure 2)
Use the fasteners after holes are drilled. Failure
to do so will void the fire rating.
Figure 2
-6-6.
*
1120 IH-8939