Kichler 330165 Manual De Instrucciones página 9

Hanger ball
HANGING THE MOTOR ASSEMBLY
Cross pin
Standard Ceiling Installation
Step 1. Pass the 120-volt supply wires through the center hole in the
Ceiling canopy
ceiling hanger bracket as shown in Fig. 5.
Decoration ring
Step 2. Secure the hanger bracket to the ceiling outlet box with the
screws and washers provided with your outlet box.
Coupler cover
Step 3. Remove the hitch pin, lock pin and set screws from the top of
Downrod
the motor assembly.
Set screws
Locking pin
Step 4. Route wires exiting from the top of the fan motor through the
Hitch pin
coupler cover, canopy cover, canopy, decoration ring and then through
Fig. 6
the ball/downrod. (Fig. 6)
Step 5. Align the holes at the bottom of the downrod with the holes
in the collar on top of the motor housing (Fig. 6). Carefully insert the
hitch pin through the holes in the collar and downrod. Be careful not
to jam the pin against the wiring inside the downrod. Insert the locking
pin through the hole near the end of the hitch pin until it snaps into its
locked position.
Step 6. Tighten two set screws on top of the fan motor firmly. (Fig. 6)
Check tab
Registration slot
Step 7. Place downrod ball into the hanger bracket socket. (Fig 7)
Fig. 7
9
52" Renew Patio |