Tabla de contenido
Figure 1
Figure 2
Apply pressure to lock
Aprete la palanca para
bloquear
Presser le levier pour
verrouiller
Figure 3
Figure 4
Page 10
The Start/Stop Levers. See figure 1.
The Start/Stop levers are under the handle grips.
The Interlock Switch. See figure 2.
The interlock switch is on the handle assembly under
the Start/Stop levers.
The Locking Lever. See figure 3.
The locking lever is on the bottom of the handle
assembly at the back of the machine.
HOW TO PREPARE THE MACHINE
FOR OPERATION
WARNING: Always remove the electrical plug
from the electrical outlet before
installing or removing a brush or
accessory.
To connect a brush or pad driver, follow this procedure:
1. Put the handle in the vertical position.
2. To fasten the handle, press down on the locking
lever.
3. Put the handle on the floor.
4. Put one foot on each side of the machine. See
figure 4.
5. Fit the lugs on the bottom of the machine into the
openings in the brush.
6. Turn the brush or accessory clockwise to lock it
into position.
7. Turn the brush or accessory counterclockwise to
unlock and remove the brush or accessory.
8. Lift the machine to the vertical position.
NOTE: To prevent damage to the brush or pad
driver, remove the accessory while not in use.
To connect a solution tank, follow the instructions
given with the tank.
Clarke
®
Operator's Manual FM-1500HD, 1700HD, 2000, & 2300
THE CONTROLS
Tabla de contenido
