Repair Parts - STAR Water Systems 148014 1HP Manual De Instrucciones

TROUBLESHOOTING
PROBLEM
Clogged or restricted strainer or suction line. Contact a qualified repair professional.
Undersized pool piping.
Plugged or restricted discharge line of filter,
valve partially closed (high gauge reading).
E. Low Flow
Air leak in suction (bubbles issuing from
return fittings).
Plugged, restricted, or damaged impeller.
1. Air leak in suction piping, cavitations
caused by restricted or undersized
suction line or leak at any joint, low
water level in pool, and unrestricted
discharge return lines.
2. Vibration due to improper mounting, etc. 2. Replace mounting.
3. Foreign matter in pump housing. Loose
F. Noisy Pump stones/debris hitting impeller could be
cause.
4. Motor bearings noisy from normal wear,
rust, overheating, or concentration of
chemicals causing seal damage which
will allow chlorinated water to seep into
bearings wiping out the grease causing
bearing to whine.

REPAIR PARTS

ITEM P/N
A
025467
B 025466
C 025465
D
025468
CHECK FOR:
DESCRIPTION
Cover with O-Ring
Filter/Strainer Basket
Drainage Plug with O-ring
Spanner - Tool for Opening the
Transparent Cover
Copyright © 2020. All rights reserved • 95 North Oak Street • Kendallville, IN 46755
Correct piping size.
Sand filters - backwash as per
manufacturer's instructions; D.E. filters -
backwash as per manufacturer's instructions;
Cartridge filters - Clean or replace cartridge.
Re-tighten using Teflon tape.
Replace, including new seal assembly.
1. Correct suction condition or throttle return
lines, if practical. Holding hand over fitting
will sometimes prove this point or putting
in a smaller eyeball fitting.
3. Clean the pump housing.
4. All seal leaks should be replaced at once.
A
B
15
SOLUTION
D
C
IL2594