Identification Label; Installation; Connection High Pressure Outlet; Connection To Water Supply - Interpump Group Blue Time Manual De Instrucciones

4.2 - IDENTIFICATION LABEL

Before using the machine, make sur e that it is provided with
the identification label.
missing, do not use the machine and consult your dealer imme-
diately.
The identification label with the technical specifications is fixed
to the machine.
Check that ID label specifications corr espond to those r equired
and that the power characteristics for the outlet (V/Hz) ar e those
shown on the label.
5.1 - HIGH PRESSURE CONNECTION
1. Insert the lance in the gun and tur n the nut to tighten it safely (A).
2. Connect the high pressure hose to the OUTLET port (B) and tighten the nut.

5.2 - CONNECTION TO WATER SUPPLY

1. The maximum temperature of the inlet water must not exceed 60°C (140°F).
2. WARNING: You can connect the machine INLET fitting to the mains water supplyonly
by installing:
• an approved check valve in compliance with IEC EN 61770 on the mains water sup
ply outlet.
• and using a hose with inside diameter of at least 13 mm. (1/2") in compliance with IEC EN
61770.
3. Considering that the water flow decr eases in accordance with the length of the hose,
make sure that the quantity of water r eaching the machine is at least 10 lpm.
4. The pressure of the inlet water must not exceed 10 bar , 1 MPa, 145 psi.
ATTENTION: The water supply which enters into the washer is not drinkable.
If the user wishes to power the washer by means of free suction, simply emerge the end of the
supply tube in the water to be suctioned. The maximum suction depth consider ed as the dis-
tance in height between the water surface and the pump is 1 m.
IMPORTANT
Make sure that the machine is fed with clean water during use.
Running the machine without water
chemicals, causes serious damage to the machine.
In case the identification label is

5 - INSTALLATION

A
INLET
Ø 13 mm.
, or with dirty , sandy water or containing corr
10
B
OUTLET
osive