Overload Protection - SNOWJOE SUNJOE CJ602E Manual De Instrucciones

2. Use the paddle to push the material inside the hopper if
needed (Fig. 15).
Fig. 15
m
WARNING!
Never put your hands into the hopper
while the wood chipper + shredder is running. Always use the
paddle supplied with your shredder to push items into the
hopper.
3. Only insert as much material as needed to prevent
blockage of the feeding funnel. Chop garden waste that
has been stored for a few days and is wilted and damp
alternately with dry branches. This prevents the cutting
blades from blocking up. Branches with leaves must be
completely chopped before new material is fed. Make sure
that the chopped material can fall freely from the ejection
slot.
4. Keep hold of branches while feeding them into the wood
chipper + shredder until they are automatically drawn in.
5. Keep to the working speed of the wood chipper +
shredder and do not overload it.
6. To protect the wood chipper + shredder from clogging,
shred wilted garden waste that has been left to dry for a
few days and shred thin twigs alternately with branches.
7. Before you shred roots, remove any remaining soil and
stones from them.
8. Do not shred soft, damp material such as kitchen waste;
take it straight to be composted.
9. Keep a few dry branches for the end, as they will help
clean the wood chipper + shredder.
10. Only switch the wood chipper + shredder off after all of
the shredding material has passed through the discharge
chutes. Otherwise, the discharge chutes may jam the next
time the shredder is turned on.

Overload Protection

Your electric wood chipper + shredder is designed with
overload protection. If the shredder is clogged during
shredding, the overload protection will cut the power
automatically to protect your shredder. Wait at least 1 minute
before restart the unit when the power is cut.
1. To restart the wood chipper + shredder, first press the
Paddle
2. Then, push the removable safety switch to ON position to
Care + Maintenance
m
maintenance, disconnect the unit from the power supply.
m
maintaining.
Cleaning
1. Use only a warm damp cloth and a soft brush to clean
2. Never spray water on the wood chipper + shredder or
3. Make sure the ventilation slots are always kept clean and
4. Open the hopper to clean the inside of the unit. Unscrew
10
reset button (Fig. 16).
Fig. 16
Reset
button
restart the wood chipper + shredder (Fig. 12).
ATTENTION!
Before performing any cleaning or
WARNING!
Always wear gloves when cleaning and
your wood chipper + shredder.
wash it with water. Do not use detergents or solvents as
these could cause irreparable damage to your shredder.
are free of debris.
the hopper locking knob counterclockwise, and remove
the hopper (Fig. 17).