Replacing The Squeegee Rubber Blades; Cleaning The Recovery Water Tank; Replacing The Fuses; Wiper Adjustment - Ghibli & Wirbel FR30 TOUCH Serie Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
12.1.f - Replacing the squeegee rub-
ber blades (Fig. 20)
When it becomes clear that drying the floor
is difficult or traces of water remain on the
floor, it is necessary to check the wear on the
squeegee rubber blades (60):
- Remove the squeegee unit (11) as in-
dicated in the "Cleaning the squeegee"
paragraph.
- Press the locking device (67) and open
the handle (68).
- Remove the two rubber mounting strips
(69) and remove the outer rubber (70).
- Loosen the two turnbuckles (71) and re-
move the locking bar (72) and the inside
rubber (73).
NOTE:
When the rubber blades (70) or (73) are worn
on one side, on one occasion they may be
turned over.
- Replace or turn over the rubber blades
(70) or (73) without inverting them.
- Replace all the components in reverse
order.
NOTE:
It is possible to have two types of rubber
blade.
Para rubber blades for all types of floor and
polyurethane rubber blades for mechanical
workshop floors which are dirty with oil.
12.1.g - Cleaning the recovery water
tank (Fig. 21)
Remove the upper cover to access inside the
recovery water tank.
- Loosen the knob (75) and remove the fil-
ter (76).
- Wash the filter (76) with running water
and replace it in the machine, tightening
the knob (75).
12.1.h - Replacing the fuses (Fig.
6-22)
WARNING:
Replace the blown fuse with one with the
same amperage.
- Remove the plug (35) from the socket
(39).
- Remove the cover (61) unscrewing the
screws (62) to access the fuse.
Fuse (74) - 5A
Electronic card protection.
- Put the cover (61) back on.
Fuse (63) - 75A
Battery fuse.
- In order to replace the fuse on the posi-
tive pole of the battery, do the following:
WARNING:
Check for the recovery tank to be empty.
- Disconnect the plug (35).
- Press the button (36 Fig. 6) and lift the
tank (14) until completely overturned,
then replace the fuse (63 Fig. 6).
12.1.i - Wiper adjustment (Fig. 23)
- It is possible to adjust the height of the
wiper and adjust the incidence of the
blades on the floor.
Height adjustment
- Lower the wiper, using the lever.
- Loosen the screw (55) and lift or lower
the wheel (55a) until the wiper is in the
desired position, then tighten the screw
(55).
Incidence adjustment
- Lower the wiper, using the lever.
- Start the aspirator and proceed for a few
metres, then turn off the aspirator and
stop the machine.
ENGLISH - 17