Glacier bay 35644BNHD Guía De Uso Y Cuidado página 7

Installation (continued)
5
Locating the rod placement
NOTE: Twist the tubes away from you 2.5 turns, making
the assembly longer.
NOTE: Tighten the rod set screws (DD) until it is flush
with the rods.
□ Measure the space between the walls of the bathtub or
shower where your rod assembly will be installed.
□ Extend the assembly to that measurement.
□ Lock the length of the assembly with the rod set screws (DD)
using the medium hex wrench (FF).
6
Securing the rod assembly into place
NOTE: Twist the tubes away from you to make the rod
assembly longer.
□ Make sure rod assembly is level, secure the shower rod to
the walls by twisting the end of the 7/8 in. diameter tube
assemblies (C).
□ Once the rod assembly is secure, twist the 7/8 in. diameter
tube assemblies (C) until tight.
DD
C
7
tub opening
1 in. diameter
rear
tube (D)
1 in. diameter
front
tube (D)
C